Put opener into programming mode - the openers programming window will time out after 30 seconds: The location could be anywhere on the cover of the opener or under a lens depending on the model. Locate either a square PROGRAM button (PRGM) or round LEARN CODE button on the opener (ceiling). Program the HomeLink Device to the Genie Garage Door Opener : If after holding down the HomeLink device button for 5 seconds or longer, the LEDs on the head do not light, repeat from step 1 in this section until the operator LED lights blink in response to the HomeLink device button press. If the operator LEDs light, continue to the next steps. ![]() The operator head LEDs should light in response. (Ignore the HomeLink transmitter indicator during those 5 seconds.)Ĭonfirm that the HomeLink device picked up the transmission from the remote by pressing the chosen button on the HomeLink device. When the HomeLink device indicator STOPs blinking, press and hold down the chosen button on the HomeLink device for a full 5 seconds - then release. Before you proceed, make sure the HomeLink device indicator has stopped blinking completely. The HomeLink indicator LED blinks slow at first and then change to a faster blink rate - once the blink rate changes to fast (could take up to 20 seconds) – then release both buttons. ![]() ![]() Press and hold down any button on the remote AND press and hold down the chosen button on the HomeLink device AT THE SAME TIME.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |